Plauqe mounting issue My plaque mount has mounting issues. I will send a photo of the crease.
KeenART:
This was not due to a our error. This poster had very bad water or moisture damage to the it. So where the image has been damp or wet the paper shrinks and will not lay flat (you can notice this by rubbing your hand over the poster and it does not lay flat. Therefore when we laminate and drymount the print to the MDF wood the area where the poster has been moisture damaged will crease. Unfortunately we get a lot of these damaged prints sent to us every week as it is a cheap way to have it protected. I hope this helps. If you have any further questions on this please give us a call or reply email.
Trini, | WOW I received my order and I'm impressed with the quick service, packaging, and canvas prints. Thank you so much!
Denden, | Thanks for your excellent service.Turnaround time great. Colors spot on without test strip. Will be back again.
Bryce, Lethbridge, AB | the frame looks good but... Received the frame - three points for your information.
This took 2.5 weeks to receive - in my opinion that is too long unless you indicate as such on the order
the mounting screw heads are much much too small - I have many tools - none fit your Robertson tiny heads - had to go to home depot and picked up 4x3/8 wood screws that finally worked
the mounting flanges didn't fit my frame - I had to bend them to fit - not easily done - required my vice and heavy needle nosed pliers - my print was from Walmart and so I suspect they cheaped out on the thickness of the wood in the print - but I should have been able to adapt the mounting flanges more easily
Other than that the frame looks good and works
Jejoo, |